If you are tired of buying too expensive flower pots in the store, it's time to create your own from scratch! For example, from concrete you can create high-quality flower pots right at home.

You will need the following materials: two tanks (both identical size, but different diameters), vegetable oil, PVC pipe (D = 20 mm), knife, rubber gloves, concrete mix; Bucket, shovel, film.

Preparation of the template.
Diagram The pot requires the use of two containers of the same, but different sizes - one must be slightly more different - to successfully complete the project. To create a flower pot according to the drawing, you can use bowls, buckets, plywood boxes or anything else that you have at hand.

They should be labeled so that the concrete pot is free from the forms when it is completed. Vegetable oil should be sprayed both inside and outside the largest and most small tanks. In wooden tanks, instead of oil uses wax to prevent rotting.

PVC tube should be cut into two or three sections. They will serve drainage holes for a flower container, and pipe segments should be about 5 cm long.

First of all, rubber gloves should be used to protect your hands from concrete. Prepare the quick-drying concrete mass in accordance with the instructions on the box. At this stage, if you want your flower pot to be colorful, you must mix concrete paint with water.

The finished concrete mass is poured into the largest container with a thickness of 5 cm, starting from the bottom of the container. Insert the tubes to the table center at a distance of 7-10 cm from each other.

Make sure you carefully placed a small tank in the middle of the greater. Place the reservoir of smaller size directly on the tube, slightly touching them. Make sure that the upper container is located in the center inside the bottom container, otherwise the edge of the pot will have different thickness, and the drainage holes will not be located in the middle of the lower container.

Create a flower container corners to collect all this together. Fill the space between the two tanks concrete. If a spatula is required, use it. Carefully knock the tank over a solid surface several times to make sure that the concrete is distributed evenly. Then the concrete should be re-apply to the tops of the tanks. Using a spatula, smooth the edges.

Give the product to dry at least 24 hours before carefully removing the inner container. Cool water should be slightly sprinkled inside the open concrete pot so that it remains wet. Use a sprayer for this. Официальный сайт Cat Casino